Magnum 6500 Owner's Manual - page 42
42
ORDER #
DESCRIPTION
AFP24
Spring Handle, Gold, Heat Exchanger Rod
CF02
Ash Pan Assembly, MagnuM 7500
CF06
Firepot, Stainless Steel, Corn/Biomass, 7500
CF13
Door, Black, 6500 & 7500, Countryside (when purchased separate from unit)
CF22
Filter, Cold Air Return, MagnuM 6500 & 7500
CF23
Fan Limit Control, MagnuM 7500 furnace 2004 or earlier, 2E232 (control only, wiring harness sold separate)
CF25
Blower/Fan, Room, Complete Assembly (when purchased separate from unit)
CF26
Motor, Auger Feed Gear, 8 rpm (MagnuM 7500 only)
CF27
Combustion Enhancement System
CF33
Motor, Furnace Blower, ¼ hp single speed (3M393) 2004 and older MagnuM 7500 (formerly part CF24)
CF35
Mount, Motor, New Auger Motor, Retro-Fit Kit (7500 furnace 2003 or earlier) not for new units
CF37
Scraper Assembly, Firepot, 6500
CF38
Firepot, Steel Corn/Biomass, 6500
CF40
Ash Pan Assembly, MagnuM 6500
CF3515
Door, 24K Gold, 6500, & 7500, Countryside (when purchased separate from unit)
CF3519
Door, Nickel, 6500 & 7500, Countryside (when purchased separate from unit)
MF3650
Draft/Exhaust, 2-speed Output Blowers, MagnuM 6500
MF3511
Bushing, Bronze (fuel stirrer shaft bearing) 2 pcs. (7500 & all countryside models)
MF3513S
Fuel Stirrer, Welded, Stainless Steel, 7500
MF3514
Drive Shaft Assembly, Fuel Stirrer, 7500 (includes P003088 ½” ID collar)
MF3516
Chain, Fuel Stirrer, 7500
MF3517
Sprocket, Fuel Stirrer, 11-tooth sprocket on motor, 3/8” Diameter shaft, 7500
MF3518
Sprocket, Fuel Stirrer, 11-tooth sprocket on shaft, ½” Diameter shaft, 7500)
MF3521
Scraper Assembly, Firepot, 7500 (all product models except 6500)
MF3523
Door Handle Assembly 7500, 6500, all Countryside models
MF3526
Shoulder Bolt, with nut, ¼-20, Door Latch
MF3527
Hinge, Door (each) takes two (2) per unit
MF3530
Auger, 1 ½” Corn/ Wood Pellet/ Biomass, 7500 (3500P, 3500L, 3502 models)
MF3531
Glass, Door (all models of Countryside & 7500, 6500 Corn Furnace)
MF3532F
Cord, Power, 7500 & 6500 furnace
MF3537
Safety Sensor, Low limit/Fan, 110 deg. (located on Exhaust Manifold & upper air shell, left side)
MF3540
Motor, Fuel Stirrer, MagnuM 7500 & all MagnuM Countryside models
MF3573
Motor, Auger Feed Gear, 4+ rpm (MagnuM 6500) Also used on MagnuM Countryside models
MF3592
Thermostat, Millivolt
MF3593
Control Board, MagnuM 7500 (current board used on Countryside)
MF3594
Control Board, MagnuM 6500
MF3610
Gasket, Exhaust Draft Motor (all models)
P6006
Auger, 2” Corn/Wood Pellet / Biomass, 6500
P7541
Rod, Heat Exchanger, MagnuM 7500
P7554
Brick board, 6500 & 7500B
P003015
Slides, Clean Out, left or right front, MagnuM 7500
P003053
Screw, Hex, #8 x ½” Tek ¼”
P003054
Screw, Phillips, #10-32 x 3/8”
P003073
Door, Clean-out, left or right lower back corners on MagnuM 7500 Furnace
R-116NKL
Spring Handle, Nickel, Heat Exchanger Rod (when using Nickel plated door)
R0117
Plug, Clean-out, 1 1/2” diameter knockout plug
RP2050
Thermostat, Hi-Temp, Manual Reset, 225 Deg. 7500 & 6500
AMERICAN
ENERGY SYSTEMS, INC.-
Order placement: e-mail: dealersales@magnumheat.com
Fax 320-587-8872 or call (800) 495-3196 Technical Support Call (320) 234-0743