Magnum MFM-PS Product Instruction Manual - page 18
18
4.2 Non-Standard size paper fold storage
Measure non-standard size paper length, press Select key to Paper length input mode, press
Clear/Reset key. Input paper length using numerical keys,
(Note: number should be bigger than B6, smaller than A3, otherwise can’t work. Non-standard size
paper length storage)
After inputting paper length, press Store key, select 1 or 2 to be stored. (Press Store key, and release,
store lamp will light between 1 and 2; Hold press Store key until the “beep” sound, means paper
length stored) When paper length is stored, system will adjust 6 fold types according to the length.
Select one fold type, press Test key to check if fold is correct. (If fold incorrect or slating, refer to
chapter 9 Adjustment)
(Note For non-standard size paper, to store adjustment of table A’s stopper position, hold press Store
key until “beep” sound. Same for Table B, hold press Store key until “beep” sound to store).
Example: Paper length has been stored; Store lamp 1 is on; Adjust fold speed; Select one fold type;
Press Select Key to choose Table A stopper move mode lamp, use +/-key to adjust and press Store key
to store. Same for Table B stopper move mode lamp, use +/-key to adjust and press Store key to store.
Next time, choose same paper same fold type.
4. Storage
4.1 Standard-size paper fold storage
After adjusting the standard paper (A3,B4,A4,B5,A5,B6), it
would be stored into fold type key. One fold type key can
store 6 kinds of standard-size paper. (Maximum storage: 6 x
6=36)
You are able to store the folding speed, the positions
of the Table A and B.
Prepare for the fold type to be stored:
Choose standard-size paper, choose fold type, (in this
case, A4, Letter folding are selected) Adjust the Table A
and B position, adjust fold speed.
After all adjustment are set, hold press the Select key,
until “beep” sound. The lamp of the fold type you chose
will flash. Select the same paper, same fold type next
time, this lamp will flash.