Magnum MFM-PS Product Instruction Manual - page 7
7
Operation Panel and Functions
No. Designation/Indication
Function
(1)
Speed adjustment key
Used for adjusting the speed.
(2)
Store key
Select memory 1/2 stored folding position and the folding
position after adjustment is stored.
(3)
Memory 1/2 lamp
Two special folding types are stored.
(4)
Select key
Used for selecting paper length, the feed position of table A and B,
indicating of the counter when lights are off.
(5)
Paper length input mode lamp It is on when paper length is input, if non-standard size paper,
press CLEAR/RESET, input correct paper length.
(6)
Table A stopper lamp
Lights when the position of stopper of table A can be adjusted.
(7)
Table B stopper lamp
Lights when the position of stopper of table B can be adjusted.
(8)
+/- key
Used for adjusting the position of the stopper of table A and B.
(9)
Fold type key
Six folding types & six types of paper can be selected and stored.
(10) Numerical key 1
Used for inputting the reduced number for subtraction counting
and the length of non-standard size paper.
(11) Counter
Shows the number of sheets, the position of the stopper pin of
table A and B, and paper size.
(12) Clear/Reset key
Clears counter indication and resets error. When the paper length
lamp is on, press this key, can input non-standard size paper.
(13) Test key
Test fold one sheet (stopper of table A and B move to the position).
(14) Start/Stop key
Starts and stops the system.
(15) Status lamp
Lights when paper stock runs short, or indicates the location
when feed trouble occurs.