Magnum MI-76100 Operating Manual - Assembly Instructions
2
ASSEMBLY INSTRUCTIONS
MAGNUM INDUSTRIAL MI-76100 & MI-76150 DRILL PRESSES
•
Before you assemble your drill press, review the parts breakdown and keep it ready for reference.
•
Start by removing the parts from the packaging.
•
Carefully check the packaging for small pieces before you continue.
•
Lay out the parts on a large, clear and unobstructed area and ensure that all parts are accounted for.
•
If you have any questions or require further information, please contact the KMS Tools Service Department at 604.395.4134
or email
repairs@kmstools.com
ASSEMBLING THE DRILL PRESS
1. Bolt the BASE FLANGE (4) and COLUMN (19) to the BASE (1).
2. Carefully remove the RACK COLLAR (21) from the COLUMN (19). Apply even pressure and gently slide the COLLAR. Using
too much force can cause the COLLAR to bind. If it is tight, try gently tapping the COLLAR.
3. Ensure that the WORM GEAR (10) and HELICAL GEAR (9) are installed in the TABLE BRACKET (7) and have not fallen out
during unpacking.
4. Place the RACK (18) into the TABLE BRACKET (7). The tapered end of the RACK faces upward and the square end faces
downward.
5. Lower the RACK (18) and the TABLE BRACKET (7) onto the COLUMN (19). Take care to hold the two pieces together. This
may require two people.
6. Fit the bottom lip of the RACK (18) in the friction ring on the BASE FLANGE (4). Secure the top of the rack by installing the
RACK COLLAR (21). Tighten the SET SCREW (20) in the RACK COLLAR (21). Take care not to over tighten.
7. Slide the CRANK SLEEVE HANDLE (6) on the WORM GEAR (10) and secure it with the SET SCREW (5).
8. Lower the HEAD (26) to the COLUMN (19) and secure the HEAD (26) by tightening two SET SCREWS (26-1). This may
require two people.
9. Secure the TABLE (17) onto the TABLE ARM (12).
10. Attach a HANDLE KNOB (23) to each of the three FEED HANDLES (22). Then secure the HANDLES (22) to the PINION
SHAFT (24).
11. Thread a light bulb (maximum 40 watts) into the LAMP HOLDER (32). (Light bulb sold separately.)
12. Remove the protective coating from all surfaces using a rag dipped in environmentally safe degreaser
INSTALLING THE CHUCK
1. Degrease all pieces. Slide the ARBOR (53) into the SPINDLE (51), flat end up.
2. Slide the CHUCK (54) over the tapered end of the ARBOR (53) and, using a wooden mallet, give the CHUCK a good tap. The
taper is designed to hold the CHUCK securely in place.