Magnum MI-81350 Operating Manual - page 10
9
Depth of Cut
Depth of cut is determined by the height of the
infeed table relative to the high point of the
knives on the cutterhead.
When facing the width of a board (as opposed to
the edge of a board), NEVER attempt to take
off more than 1/64" with each pass.
The depth of cut is indicated by the scale located
on the front of the jointer base as shown in Fig.18.
Warning: There is a Depth Stop Limited on the
back side that must be released if
cutting a depth greater than 1/8".
If hand wheel seems jammed, please
check and release the Depth Stop
Limiter on the back of jointer.
1. Loosen the in-feed table height locking
handle (A), Fig. 18.
2. PULL out
the 1/8” depth stop plate (C)
then raise or lower the height adjustment
handle (B) to the desired depth of cut then
retighten lock handle (A) to secure the
infeed table in position, Fig. 18.
Waning : Never adjust the table height with
the lock pin engaged as this will
break the pin.
Note: Refer to the graduated depth scale
(D, Fig. 19) . Do not connect the plug
to power
source
To adjust infeed table
In addition to the 1/8” depth stop, 2 other
depth stops can be set by setting the infeed
table minimum and maximum height, Fig. 20.
To set the table minimum height:
1. Loosen locking handle (A).
2. Upper the infeed table to the desired
minimum height.
3. Check the pointer (F) on the correct
position if not, loosen the round head
phillips screw (G) make sure the pointer
on
“0” position.
4. Re-tighten locking handle (A).
To set the table maximum height:
1. Loosen locking handle (A).
2. Lower the infeed table to the desired
maximum height then re-tighten locking
handle (A).
FIG. 18
FIG. 19
FIG. 20
D
B
A
B
C
DEPTH STOP 0
G
F
DEPTH STOP 1/2
”
A