Magnum MI-81350 Operating Manual - page 11
10
N
O
P
Q
R
Table Leveling
The table level on your machine is factory
adjusted and may never require readjustment.
Should any adjustment become necessary, do
the following:
1. Loosen 8 screws (B, Fig.21) on the rear
cover by 4mm Hex. wrench , take off the rear
cover.
Fig. 21
2. Loosen 2 screws (I, Fig.22) on the front cover.
Fig. 22
3. Loosen 4 CAP screws (J) on the base frame
by 5mm Hex. Wrench, remove the front cover
(K), Fig. 23.
Fig. 23
4. Loosen CAP screw (L) on the rabbet arm by
6mm Hex. wrench, remove the blade guard
(M), Fig. 24.
Fig. 24
5. Loosen the Hex. Nut (N) under the fence
bracket (O), remove the fence assembly (P),
FigFig. 25
Fig. 25
6. Set a straightedge (Q) on the front that must
cross the infeed table & outfeed table,
adjust 4 eccentric sleeves(R) by 24mm
open wrench. Keep checking the level of
the tables with a straightedge until leveling
is achieved, Fig. 26.
Fig. 26
7. Set a straightedge (Q) on the rear that must
cross the infeed table & outfeed table,
adjust 4 eccentric sleeves (S) by 24mm
open wrench. Keep checking the level of
the tables with a straightedge until leveling
is achieved, Fig. 27.
Fig. 27
8. Put the fence .blade guard. front cover &
rear cover back to machine & tighten all of
screws.
Warning: Do not connect the plug to power
source
Q
S
M
L
K
J
I
B