Magtek IntelliStripe 60 Technical Reference Manual - page 10
IntelliStripe 60, TTL Insertion Reader
2
CONFIGURATIONS
The following part numbers are basic configurations.
Part Number
Description
21160052
No PCB, Front/Side Chassis Mount, 8 Smart Card Contacts, Gate Assembly, Card
Latch Assembly, 3 Tracks, 1 Mag Read Head, Head position opposite Smart Card,
Plastic Bezel
21160060
PCB, Front/Side Chassis Mount, 8 Smart Card Contacts, Gate Assembly, Card Latch
Assembly with Release, 3 Tracks, 2 Mag Read Head, Head position Both Sides, Plastic
Bezel, Card Present Switch
RELATED DOCUMENTS
The IntelliStripe 60, TTL Insertion Reader will read cards that meet the standards defined by ISO
(International Standards Organization):
ISO 7811
Identification Cards - Mag-stripe Cards, Tracks 1-3
ISO 7810
Identification Cards - Physical Specifications (ID-1 Cards)
Available from ANSI, Phone 212-642-4900; www.ANSI.org.
For further information about magnetic stripe readers, refer to MagTek part number 99875148,
I/O Interface for TTL Magnetic Stripe Readers, Technical Reference Manual.
SPECIFICATIONS
Specifications for the Reader are listed in Table 1-1.
Table 1-1. Specifications
DATA FORMAT SPECIFICATIONS
Reader Configuration
Track 2
Track 1,2
Track 2,3
Track 1,2,3
Data Format Specifications*
ISO/ANSI/AAMVA/CDL/210bpi on TK2 formats
ISO/ANSI/AAMVA/CDL/ 210bpi on TK2 formats
ISO/ANSI/AAMVA/CDL formats
ISO/ANSI/AAMVA/CDL formats
* ISO (International Standards Organization), ANSI (American National Standards Institute), AAMVA,
(American Association of Motor Vehicle Administrators), CDL (California Drivers License)
OPERATIONAL
Card Speed:
3 IPS (7,62cm/sec) to 50 IPS (127cm/sec)
Recording Method
Two-frequency coherent phase (F2F)
MTBF
Electronics: 125,000 hours
Head: 1,000,000 passes (500,000 Insertion Cycles)
SC contacts: 1,000,000 passes