Magtek IPAD Installation And Operation Manual

Summary of IPAD

  • Page 1

    Ipad installation and operation manual part number: 99875382-2 august 2009 registered to iso 9001:2000 1710 apollo court seal beach, ca 90740 phone: (562) 546-6400 fax: (562) 546-6301 technical support: (651) 415-6800 www.Magtek.Com.

  • Page 2

    Ii copyright © 2007 - 2009 magtek ® , inc. Printed in the united states of america information in this document is subject to change without notice. No part of this document may be reproduced or transmitted in any form or by any means, electronic or mechanical, for any purpose, without the express w...

  • Page 3

    Iii limited warranty magtek warrants that the products sold pursuant to this agreement will perform in accordance with magtek’s published specifications. This warranty shall be provided only for a period of one year from the date of the shipment of the product from magtek (the “warranty period”). Th...

  • Page 4

    Iv fcc warning statement this equipment has been tested and was found to comply with the limits for a class a digital device pursuant to part 15 of fcc rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial enviro...

  • Page 5

    V table of contents section 1: introduction and specifications ............................................................................. 1 product description ...................................................................................................................... 1 design objective...

  • Page 6

    Vi figure 4-4. Example of user screen to manually enter card data ............................................. 15 figure 4-5. Example of user screen to select card type ........................................................... 15 figure 4-6. Example of user screen to enter pin ......................

  • Page 7

    1 section 1: introduction and specifications product description the ipad is a secure pin entry device combined with magtek’s 3-track magnesafe™ secure card reader. Ipad provides the most comprehensive end-to-end security solution to prevent personal cardholder data breaches while bringing convenien...

  • Page 8

    Ipad installation and operation manual 2 design features • pci ped v2.0 certified • 3des encryption • dukpt key management • remote key injection • card and data authentication • device authentication • mutual authentication • flexible data formats • flexible data masking • real-time electronic sign...

  • Page 9

    Introduction and specifications 3 major components the major components of the ipad are shown in figures 1-2 and 1-3. Figure 1-2. Major components (front).

  • Page 10

    Ipad installation and operation manual 4 figure 1-3. Major components (back).

  • Page 11

    Introduction and specifications 5 specifications electrical power input: usb bus powered voltage: 5vdc current: 100ma (500ma maximum) interfaces: usb 2.0 (usb 1.1 compatible) display type: backlit, liquid crystal display (lcd) display resolution: 128 x 64 dpi flash memory: 256kb internal ram memory:...

  • Page 12

    Ipad installation and operation manual 6 pinout on rj-12 (or rj25) 6-pin connector rj 12 or 25 connector signal 1 vbus 2 usb_dm 3 usb_dp 4 gnd 5 nc 6 cgnd figure 1-4. Rj-12 (or rj25) 6-pin connector.

  • Page 13

    7 section 2: system requirements & device features system requirements • windows xp or later (32-bit or 64-bit) • microsoft .Net framework version 2.0 (not required but suggested) • usb port upon installation, windows will automatically recognize and install the usb drivers for the device. Device fe...

  • Page 14

    Ipad installation and operation manual 8 card reading the ipad contains a magnesafe reader that encrypts card data at the point of swipe to protect the cardholder’s personal information. The reader incorporates magtek’s 3-track encrypting intellihead, a magnetic read head which has encapsulated and ...

  • Page 15: Section 3: Installation

    9 section 3: installation hardware installation to connect the ipad to a computer, connect its usb cable to the usb port on the computer as shown in figure 3-1. Note: the standard usb cable p/n 30019317 is six feet long. Warning connecting or disconnecting the usb cable from the back side of the ipa...

  • Page 16

    Ipad installation and operation manual 10 privacy shield installation to install the privacy shield shown in figure 1-1, follow the steps below 1. Place the inserts of the curved side of the privacy shield into the opening located on the front surface of the ipad as shown in figure 3-2. 2. Align the...

  • Page 17

    Installation 11 privacy shield removal to remove the privacy shield shown in figure 1-1, follow the steps below. 1. Grasp the privacy shield as shown in figure 3-3 and slowly lift the edge closest to the lcd. 2. When the top guide pins are free of the ipad surface as in figure 3-2, lift the privacy ...

  • Page 18

    Ipad installation and operation manual 12 mounting dimensions the overall dimensions of the unit and the mounting hole locations are shown in figure 3-4. This drawing is not to scale and dimensions are given in inches. In addition, mounting the ipad to a surface will require size # 4-40 screws. Note...

  • Page 19: Section 4: Operation

    13 section 4: operation overview during normal operation, the operator will select the type of transaction from the pc application controlling the ipad and the cardholder will enter data on the ipad’s keypad in response to prompts on its lcd. Transactions may include new accounts, teller window appl...

  • Page 20

    Ipad installation and operation manual 14 card reading when the appropriate prompt appears (see figure 4-2 for an example), swipe the card with the magnetic stripe down and facing toward the keypad of the ipad as indicated in figure 4-3 below. If the magnetic stripe data could not be read, the appli...

  • Page 21

    Operation 15 manual card entry if the swiped card’s magnetic stripe is damaged or unreadable, the application controlling the ipad may prompt the cardholder to enter information from his or her card manually, as shown in the following example: figure 4-4. Example of user screen to manually enter car...

  • Page 22

    Ipad installation and operation manual 16 pin entry when pin entry is required, the lcd will prompt the cardholder to enter his or her pin (usually 4 digits in length) as required by the financial institution (see figure 4-6 for a sample lcd display). After the cardholder has entered a pin, the ente...

  • Page 23: Section 5: Maintenance

    17 section 5: maintenance cleaning periodic cleaning of the ipad’s exterior may be required. To clean the outside of the ipad, wipe down the unit with a soft, damp cloth and then wipe with a dry cloth. Caution to avoid damaging the read head, do not touch the inside of the card path with a wet cloth...

  • Page 24

    Ipad installation and operation manual 18 adjusting the lcd if it becomes necessary to adjust the lcd brightness or contrast, press the left function key, followed by “523” (corresponding to the letters “lcd”), followed by the right function key. The lcd will display the following screen: figure 5-2...