Mahlkonig VTA6S Operating Instructions Manual - page 12

|

L A D E N M Ü H L E N

S H O P   G R I N D E R S

5.  Clean the entire grinder using a fi ne brush and remove any foreign 

objects.

No coffee residues may adhere to the surfaces where 

the grinder casing and the grinder casing cover lie on 

top of one another when you put the grinder back to-

gether again.

6.  Put the grinder casing cover and the grinder casing back together 

again and fi x with 3 screws (in the case of the old model attach the 

nuts and clamps on the side again).

7.  Place the top part in position and make sure that the stop lever is 

pushed through the slot. By turning the top part to the right or to 

the left, engage the cut-out in the top part into the associated spac-

er block on the lower part.

8.  Fit the clamps correctly and tighten the star handles / round han-

dles.

Labelling: UNTEN (German) = bottom

9.  Move the grind adjustment lever into position “1” and connect to 

the electricity supply again.

Casing cover

(new model)

Cover screws

Grinding disc

* simply remove screw on both sides (same function as the screws of the cover)

Casing cover

(old model)

Nut with clamp*

Grinding disc

12