Mahlkönig W401 Operating Instructions Manual - page 13
||
L A D E N M Ü H L E N
S H O P G R I N D E R S
5. Put the upper part of the casing back on and close the quick
release locks. Make sure that the screw in the grinder casing
cover engages in the hole in the grinder casing.
There is a safety switch underneath this hole which prevents
the grinder being switched on accidentally when the upper
part has been removed.
6. Now push the cladding back onto the upper part of the ca-
sing.
Move the grind adjustment lever to the coarsest
setting on the right.
Plug the plug into the socket and switch the grinder back on
again. The coffee remains in the grinding space are now th-
rown out, therefore position a bag or a container under the
spout.
7. Now move the grind adjustment lever back into notch “1”
and the grinder is ready for grinding again.
10. Maintenance and Repair
Always pull the power supply plug out of the
outlet before carrying out any maintenance or
cleaning work on the grinder!
Check the grinder regularly for any signs of da-
mage on the power supply cable, plug, fi nger
protector, etc.
Any repairs that may be required are only al-
lowed to be carried out by authorised experts.
Please contact an authorised customer service
centre or your local dealer. 10.1 Grinding Disc
Replacement
10.1 Grinding disc replacement
If the grinding performance decreases and the ground coffee is
hot and irregular, you should change the grinding discs.
1. Open the grinder as described in “9.3 Cleaning the grinding
mechanism”.
2. After removing the old grinding discs, coffee residues must
be cleaned from the seat and surfaces of the grinding discs
before the new grinding discs can be inserted.
13