Majestic 18NB Installation And Operating Instructions Manual - page 35
35
18NB/24NB Gas Log Set
81D0108
TOUCH SCREEN REMOTE CONTROL OPERATION - SCR MODELS
Setting Privacy Code on Transmitter
Figure 45
The remote transmitter privacy
code is preset in factory. In the
event of activation or interfer-
ence from other nearby trans-
missions, change the code using
the following procedures (learn
function must be performed after
changing the code):
1. Press the ON/arrow button
and the TIMER button at the
same time to enter privacy
code setup mode.
2. The setup display is shown in
the figure. The four digits on
the top stand for the privacy
code. The default values of
the four digits will be all “1”.
3. The first digit will be flashing upon entering the setup
mode. Push the ON button to toggle its value between
“0” and “9”, and push the “OFF” button to jump to the
next digit. The next digit will then start flashing and the
first one stops flashing. Set up the four digits to your
choice between “0” and “9”.
4. After setting up all the four digits, push “OFF” to finish
the process and return to the previous mode.
5. The Signature Command control board then needs to
re-learn the new setting.
Performing Learn Function
1. The RF receiver button on the control board in the
fireplace must be in the on position before the learn
function can begin (refer to figure for location). With
the Command Center master switch in the ON posi-
tion, use paper clip to depress the recessed button on
Control Board, one beep for RF receiver ON or two
beeps for RF receiver OFF.
2. Holding the OFF
button on the Com-
mand Center while
turning
on
the
master switch will
activate the learn
function for the
transmitter.
3. After the above op-
eration, two beeps
will be given and the
green LED on the
Command Center
will flash for 10 sec-
onds.
FP2661
set privacy code
Figure 45
FP2650
command ctr ctrl brd
RF
Receiver
ON/OFF
Control
Board
Figure 46
4. During the 10 seconds, press the OFF button on the
transmitter to learn. Another two beeps will be given to
confirm a successful learning.
FP2650
command ctr ctrl brd
Battery Door
Master Switch
ON
LED
OFF
FP2650
Command
Center
Figure 47
W
ARNING
Do not use two (2) or more remote control sys-
tems in the same area with the same privacy
code setting, as they will communicate with
each other. This may cause the appliances to
malfunction.
Resetting the transmitter
If the transmitter is not working properly, reinstall the bat-
teries to reset the transmitter.
1. Pull out at least one of the batteries.
2. Press any key on the screen to discharge.
3. Wait for 10 seconds and reinstall the batteries.
Pushing and holding any key for more than 10 seconds
until the display refreshes will also reset the transmitter.
n
Functions and Operations
General
The TSTSC Remote Control has four (4) operating
modes: Manual, Timer, Thermostatic and Smart Mode.
The control system can be set to temperature range be-
tween 45° F and 90° F. The flame height can be adjusted
in the manual and thermostatic mode. The Smart Mode
will automatically adjust flame height according to the dif-
ference between Set and Room temperatures.
The transmitter will operate the remote receiver from 1
foot to a maximum of 30 feet. The distance is reduced
when batteries are low.
Manual Mode
Figure 48
In this mode, the TIMER/THERMO buttons will only dis-
play “TIMER” / “THERMO”, without showing the time and
the SET temperature. Pressing the ON/up and OFF/down
buttons will change the flame height and turn on/off the
fireplace if the TIMER/THERMO buttons are not pressed
and flashing.