Summary of DynaMix
Page 1
V 1.0
Page 2
2 table of contents: ----------------------------------------------------2 limited warranty: ----------------------------------------------------3 installation: ------------------------------------------------------------4 overview:------------------------------------------------5 panel controls: --...
Page 3
Limited warranty: 3 about this manual: written by tony rolando and walker farrell illustrated by w.Lee coleman make noise warrants this product to be free of defects in materials or construction for a period of one year from the date of purchase (proof of purchase/invoice required). Malfunction resu...
Page 4
4 please refer to your case manufacturers’ specifications for location of the negative supply. Installation electrocution hazard! Always turns the eurorack case off and unplug the power cord before plugging or un-plugging any eurorack bus board connection cable. Do not touch any electrical terminals...
Page 5
Overview dynamix is a fast two-channel low pass gate, dynamics manager and mixer, the core of which is derived from our 0-coast synthesizer. The level parameter provides simultaneous voltage control over the amplitude and frequency content of audio signals, operating as a vcf/a. The dynmc parameter ...
Page 6
Panel controls 1. Channel 1 signal input: direct coupled signal input capable of accepting audio or control signals with a range of around 10vpp. 2. Channel 1 signal input drive: input attenuator for associated signal input. Unity gain around 1:00. Begins to overload the dynamic circuit after about ...
Page 7
7 getting started it’s a vca, it’s a vcf... The low pass gate operates simultaneously in the amplitude and frequency domains. When a control signal is patched to the level input, as it becomes more positive, the amplitude of the processed signal increases, with the lower frequencies being more quick...
Page 8
Dynamics management the dynamix dynmc input allows for audio signals to be used as control signals. Audio signals patched to the dynmc input are averaged to the point of creating a smooth positive control voltage. The associated dynmc attenuverter allows for adding or subtracting these positive cont...
Page 9
9 tips and tricks -if you have nothing patched to the dynmc input, be sure to remember the normalization of the signal input to the dynmc input. Setting the associated dynmc attenuverter to 12:00 or simply patching a dummy cable makes certain there is no unwanted influence. -the dynmc input may act ...
Page 10
10 patch ideas the new vactrol free bongo: set up a vco for two-operator fm by applying a sine wave to its linear fm input or using the dpo’s fm bus and patching the resulting waveform to dynamix’s input. Set the associated attenuator to 4:00. Patch an exponentially-shaped envelope cv with a fast ri...