Make Noise Rosie Manual - page 5
5
Rosie Panel Connections
1
2
3
6
7
12
5
4
8
10
11
13
9
1. Channel A Signal Input: expects typical 10Vpp Audio signal from Modular System. AC coupled.
2. Channel B Signal Input: expects typical 10Vpp Audio signal from Modular System. AC coupled.
3. Channel A Level Indicator: LED lights to show strength of signal patched to Channel A input.
4. Channel B Level Indicator: LED lights to show strength of signal patched to Channel B input.
5. Crossfader: selects between Channel A and B or some combination of A and B to be sent to FX Send and Master Line Output.
6. FX Send output: Mono 10Vpp Audio signal intended to be patched into the Modular System. Also possible to use with
external
Line Level devices if attenuation is applied.
7. FX Return input(s): operates as Mono (use only top jack, marked M) or Stereo (use both Jacks marked M and ST) return for
the FX Loop. Expects typical 10Vpp Audio signal from Modular System. AC coupled. May be used with Line
Level devices as well (set Return Level to Max and adjust output volume at external device).
8. Return Level: manually operated panel control to set the Level of the FX Loop Return in the Master Output. Range of 0% to
120%
9. Master Level: Sets the volume of the Master Line Output.
10. Overload indicator: OVL lights when signal Level is too high.
11. Master Line Output: 1/4" TRS jack wired as Stereo output. Low output impedance (60 ohms) allows this output to drive
Headphones as well as Line Level Inputs.
12. CUE Level: Sets volume of the signal for CUE Headphones Output.
13. CUE Output: TRS Mini-Jack wired as MONO. Low output impedance (30 ohms) allows this output to drive Headphones, as
well
as Line Level inputs.