Makeblock mDrawBot Kit User Manual - page 19
mScara mSpider
mEggbot
mCar
mScara mSpider
mEggbot
mCar
Screw M4×16(2)
Nut M4(2)
13
4×7×3(2)
(1)
Me Stepper
Motor Driver
Screw M4×16(2)
Nut M4(2)
14
4×7×3(2)
(1)
Me Stepper
Motor Driver
Screw M4×8(2)
Nut M4(2)
15
Refer to Page 8
16
6P6C RJ25 Cable-20cm(2)
6P6C RJ25 Cable-35cm(1)
Assembled Diagram
Software & Related Details
Working With mDraw
Makeblock Orion Driver Installation
The USB interface of Makeblock Orion uses the chip CH340,you may need to install the chip
Ch340 driver manually.
Visit the following URL for more details:
http://learn.makeblock.cc/driver_installation/
Stepper Motor B
Stepper Motor A
Microstep Resolution:HHH
9g Micro Servo
Connect to Slot2
H
L
35
34
Wiring
mDraw is the software designed to work with the mDrawBot. It's required to download,
install mDraw, and use it correctly in order to make your mDrawBot move.
1. Visit
to download mDraw and related specific instruction.
http://learn.makeblock.cc/mdrawbot/
Note: It's required to download the material mentioned above.
2. It's strongly recommended that you should read the specific instruction before using the software.
3. Here's the basic interface of mDraw.
(More details are included in the package downloaded from the URL mentiond on Step 1.)
mDraw is an open source project hosted on Github. Fork it here:
https://github.com/Makeblock-official/mDrawBot/