MakerBot Replicator Mini+ User Manual - page 18
CONNECT TO A NETWORKED PRINTER
To Connect to a Networked Printer
1. Open the MakerBot Mobile App and log in with your credentials on your mobile device.
a. For iOS users, tap
Add a Printer.
b. For Android users, tap the
Printers icon, or tap the Navigation button and tap Printers.
2. You will be taken to the
My Printers screen, which will list any saved printers and will allow you to
connect to new printers.
a. For iOS users, tap
Add+.
b. For Android users, tap
Add a Printer or tap the Floating Action Button to add a printer then tap
Connect to a Networked Printer.
3. Scroll through the list of available printers already connected on the specified network and tap
on a printer.
4. You will see an information screen which lists the name of the printer, the printer type, and the printer
IP address. Once you have found the correct printer, tap
Use This Printer.
5. Push the dial on the MakerBot Replicator Mini+ control panel to authenticate the connection. On the
MakerBot Mobile App, you will see the live camera feed and print state from the MakerBot Replicator
Mini+.
To Connect to a Printer via IP Address
If you have a non-standard network setup, you may need to manually connect your 3D printer to a network
via IP address. If so, follow these steps:
1. Open the MakerBot Mobile App and log in with your credentials on your mobile device.
a. For iOS users, tap
Add a Printer.
b. For Android users, tap the
Printers icon, or tap the Navigation button and tap Printers.
2. You will be taken to the
My Printers screen, which will list any saved printers and will allow you to
connect to new printers.
a. For iOS users, tap
Add+.
b. For Android users, tap
Add a Printer or tap the Floating Action Button to add a printer.
3. Tap
Connect Via IP Address.
4. Type in the printer’s IP address and tap
OK.
5. You will see an information screen which lists the name of the printer, the printer type, and the printer
IP address. If this is the correct printer, tap
Use This Printer.
CONNECT THE MAKERBOT REPLICATOR MINI+ TO A PRINTER
START UP
18