Makisolar DR-0433-G Instruction Manual

1

Solar Light 

Instructions Manual 

For DR-0433-G 

READ THE INSTRUCTIONS CAREFULLY BEFORE ASSEMBLY AND INSTALLATION 

FIRST TIME USE: 

Remove the protective film (if have) from the solar panel before the first use

CHARGING: the product must be left to charge 2 sunny days on OFF position before best 

results are achieved. 

STEP1. Charge the solar product by placing it under direct sunshine for at least 8 hours. 

STEP2. Switch the knob to “AUTO” position and solar product will now work 

automatically, charge under direct sunshine in the day time and illuminate at night. 

NOTE: In order to verify that the knob is correctly switched to “AUTO” position, cover 

the solar panel with your hand and light will turn on automatically.   

MPORTANT:   

1. Install the solar product in an area where it can get 

direct sunshine free from cover or shade. 

2. DO NOT switch the knob to “OFF” anymore. 

3. Select an outdoor location not near to night light 

sources, such as street lights, which may cause the light 

to turn “OFF” automatically. 

4.  Duration of light depends on solar product’s level of sunshine exposure, geographical 

locations, weather conditions and the hours of daylight. 

Assembly Instructions 

Ground mounting (If stake provided)

1)  Carefully remove the solar light and all the fittings out of the box. 

2)  Assemble the body and stakes by plastic joints and ; Push the stake directly into 

the ground (DO NOT hammer the light or the stakes). 

3)  Slot the lamp head on the upper part of the mounting body carefully. 

4)  Sensor detection (If functioned): when the sensor detects movement, all LEDs 

will be turned on and keep working for 10-30 seconds and turn off automatically; 

the sensor detects an area of about 90 degrees vertically and about 90 degrees 

horizontally, with a range about 5 meters.