Makisolar DR-0433-G Instruction Manual - page 2
2
Replacing the Batteries
For best results the batteries should be replaced every 12 months.
1) Release the screws from the solar top head.
2) Remove the old batteries. Make sure the new batteries are rechargeable
batteries. (3Pcs AA Size 1000mAh 1.2V Ni-Cd)
3) Install the new batteries in to the battery compartment, ensuring the
correct polarity is observed.
4) Recover the battery compartment.
Trouble Shooting
If your SOLAR LIGHT does not lighting at dark despite observance of all the instructions,
please try the following steps:
1) Make sure that the SOLAR LIGHT is not being affected by any other light source.
2) Ensure the SOLAR LIGHT does not stand in the shade during the day.
3) Make sure the switch is in the auto position.
4) Check that the batteries are installed correctly.
Specification
Aluminum Alloy Construction
16Pcs White Color LED and 1Pc Colors Changing LED
Operating time: up to 8 hours run time with 6 hours of sun charging
No Mains Power or wiring required
Automatic sensor turns the light on at dark
3 x Solar Rechargeable AA Size 1000mAh 1.2V Ni-Cd batteries included.
Passive infrared motion detector functioned
Maintenance
Clean the solar module regularly with a damp towel to guarantee optimum performance of the
solar panel. Do not use any type of solvent for cleaning and be careful not to put too much
pressure on the module while cleaning.