Makita 4105KB Instruction Manual - Assembly
7
ASSEMBLY
CAUTION:
•
Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
Installing or removing diamond wheel
1
2
3
010834
Loosen the thumb nut, lower the base and tighten the
thumb nut in that position. Fit the socket wrench onto the
hex bolt and turn the diamond wheel until two flatted
parallel surfaces of the outer flange reach the direction in
which the wrench can be inserted.
1
2
010835
To install the wheel, follow the removal procedure in reverse.
Always install the wheel so that the arrow on the wheel points
in the same direction as the arrow on the blade case.
BE SURE TO TIGHTEN THE HEX BOLT SECURELY.
1
2
3
4
010833
CAUTION:
•
Use only the Makita wrench to install or remove the
wheel.
Dust bag
1
010836
The use of the dust bag makes cutting operations clean
and dust collection easy. To attach the dust bag, fit it onto
the dust spout. When the dust bag is about one-third full,
remove the dust bag from the tool and pull the fastener
out. Empty the dust bag of its contents, tapping it lightly
so as to remove particles adhering to the insides which
might hamper collection.
OPERATION
CAUTION:
•
Be sure to move the tool forward in a straight line
and gently. Forcing and exerting excessive
pressure or allowing the wheel to bend, pinch or
twist in the cut can cause overheating of the motor
and dangerous kickback of the tool.
010832
Hold the tool firmly. Set the base plate on the workpiece
to be cut without the wheel making any contact. Then
turn the tool on and wait until the wheel attains full speed.
Move the tool forward over the workpiece surface,
keeping it flat and advancing smoothly until the cutting is
completed. Keep your cutting line straight and your
speed of advance uniform.
1. Dust spout
1. Inner flange
2. Diamond wheel
3. Outer flange
4. Hex bolt
1. Socket wrench
2. Wrench
1. Outer flange
2. Base
3. Thumb nut