1 english ( o rigina l in st ruct ions) instruction manual double insulation warning: for your personal safety, read and understand before using. Save these instructions for future reference. Metal cutter 4131 005343.
2 english specifications model 4131 balde diameter 185 mm max. Cutting capacity 63 mm no load speed (min -1 ) 3,500 overall length 358 mm net weight 5.1 kg safety class /ii • due to our continuing programme of research and development, the specifications herein are subject to change without notice. ...
3 gea005-3 general power tool safety warnings warning read all safety warnings and all instructions. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. Save all warnings and instructions for future reference. The term "power tool" in the warning...
4 21. Store idle power tools out of the reach of children and do not allow persons unfamiliar with the power tool or these instructions to operate the power tool. Power tools are dangerous in the hands of untrained users. 22. Maintain power tools. Check for misalignment or binding of moving parts, b...
5 • when restarting a tool in the workpiece, center the blade in the kerf and check that blade teeth are not engaged into the material. If blade is binding, it may walk up or kickback from the workpiece as the tool is restarted. • support large panels to minimise the risk of blade pinching and kickb...
6 loosen the lever on the depth guide and move the base up or down. At the desired depth of cut, secure the base by tightening the lever. Caution: • after adjusting the depth of cut, always tighten the lever securely. Sighting a 1 005345 when cutting, align the a position on the front of the base wi...
7 after installing the blade, replace the dust cover. Slide the dust cover carefully so that the slot of its front fits the rib of the blade case. Make sure the dust cover fits properly then push and turn the knob counterclockwise to the symbol. 1 2 005350 rip fence (guide rule) (accessory) 1 2 0053...
8 chip disposal 1 005355 caution: • always be sure that the tool is switched off and unplugged before removing or installing the dust cover. • the dust cover may become hot due to hot chips. Do not touch the cutting chips or dust cover with your bare hand. When the cutting chips are visible through ...
9 accessories caution: • these accessories or attachments are recommended for use with your makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or attachment for its stated purpose. If you need any assist...
10
11.
12 makita corporation anjo, aichi, japan 884543e224.
