I n s t r u c t i o n m a n u a l warning: for your personal safety, read and understand before using. Save these instructions for future reference. English cordless driver drill model 6017d model 6018d model 6019d 002030
2 specifications • due to our continuing programme of research and development, the specifications herein are subject to change without notice. • note: specifications may differ from country to country. Symbols end001-1 the following show the symbols used for the tool. Be sure that you understand th...
3 general safety rules gea002-3 warning: read all instructions. Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury. The term “power tool” in all of the warnings listed below refers to your mains-operated (corded) power tool or battery- operated (...
4 20. Maintain power tools. Check for misalignment or binding of moving parts, breakage of parts and any other condition that may affect the power tools operation. If damaged, have the power tool repaired before use. Many accidents are caused by poorly maintained power tools. 21. Keep cutting tools ...
5 important safety instructions for battery cartridge enc004-1 1. Before using battery cartridge, read all instruc- tions and cautionary markings on (1) battery charger, (2) battery, and (3) product using bat- tery. 2. Do not disassemble battery cartridge. 3. If operating time has become excessively...
6 functional description caution: • always be sure that the tool is switched off and the battery cartridge is removed before adjusting or checking function on the tool. Installing or removing battery cartridge • always switch off the tool before insertion or removal of the battery cartridge. • to re...
7 speed change to change the speed, first switch off the tool and then slide the speed change lever to the “ii” side for high speed or “i” side for low speed. Be sure that the speed change lever is set to the correct position before operation. Use the right speed for your job. Caution: • always set ...
8 operation screwdriving operation for model 6017d/6018d place the point of the driver bit in the screw head and apply pressure to the tool. Start the tool. Release the trigger just as the screw bottoms out. If the trig- ger is not released, the screw may strip out the hole or the screw and/or bit m...
9 • if the tool is operated continuously until the battery cartridge has discharged, allow the tool to rest for 15 minutes before proceeding with a fresh battery. Maintenance caution: • always be sure that the tool is switched off and the battery cartridge is removed before attempting to perform ins...
Memo 10
Memo 11.
Makita corporation anjo, aichi, japan 884061b222.
