Makita BPS01 Original Instructions Manual - Prior To Use
4 ENGLISH
PRIOR TO USE
Installing the adapter
The adapter can be installed to a board (up to 8 mm or
5/16 in. in thickness) such as the inner wall of a job site
box using the supplied spanners.
Make four installation holes with a diameter of 7 mm
(9/32 in.) on a board to form the corners of a rectangle
114 mm (4-1/2 in.) high and 57 mm (2-1/4 in.) across.
Secure the adapter using the four spanners (a) and the
spanner bit supplied with the adapter.
Installing the mobile app
Supported mobile devices
Mobile device
NFC-enabled Android devices
OS
Android 4.2 or later
Note that support for all NFC-enabled Android devices
is not guaranteed.
Installing the mobile app
The app is only downloadable from the Google Play
Store. A Google account is needed to use the Google
Play Store.
NOTE: The mobile device must be connected to a
cellular network or Wi-Fi network.
NOTE: Be sure to enable Wi-Fi when connecting to a
Wi-Fi network in a Wi-Fi enabled area.
1. Go to the Google account sign-in page and create
a Google account. (If you already have a Google
account, skip this step.)
NOTICE: Read the Terms of Service and Privacy
Policy before creating a Google account. Makita
Corporation is not responsible for damages resulting
from the creation or use of a Google account.
a
7 mm
(9/32 in.) dia.
114 mm
(4-1/2 in.)
57 mm
(2-1/4 in.)
Up to 8 mm
(5/16 in.)
1.
2. Tap “Play Store” on your device to sign in to the
Google Play Store.
2.