Instruction manual aluminum groove cutter ca5000 eng lish: o rig in al in stru cti on s double insulation read before use..
2 english specifications model: ca5000 groove cutter blade diameter 118.0 mm max. Cutting depth (with groove cutter blade) 11.0 mm no load speed 2,600 - 6,400 min -1 overall length 346 mm net weight 5.1 kg safety class /ii • due to our continuing program of research and development, the specificatio...
3 english 2. Use personal protective equipment. Always wear eye protection. Protective equipment such as dust mask, non-skid safety shoes, hard hat, or hearing protection used for appropriate conditions will reduce personal injuries. 3. Prevent unintentional starting. Ensure the switch is in the off...
4 english — when the blade is pinched or bound tightly by the kerf closing down, the blade stalls and the motor reaction drives the unit rapidly back toward the operator; — if the blade becomes twisted or misaligned in the cut, the teeth at the back edge of the blade can dig into the top surface of ...
5 english 3. Assure that the base plate of the saw will not shift while performing the “plunge cut” when the blade bevel setting is not at 90 °. Blade shifting sideways will cause binding and likely kick back. 4. Always observe that the guard is covering the blade before placing saw down on bench or...
6 english 0 mm depth is set properly when the tool is shipped from the factory, but if you changed the depth of groove by the adjusting knob, refine the 0 mm depth as follows: 1. Turn the quick stop to 0 mm. 2. Turn the depth adjusting knob to adjust the depth. 3. Make sure that the blade does not m...
7 english 1 1. Speed adjusting dial guide plate for aligning the guide rail (optional accessory) with the cutting line, use the guide plate. 2 1 3 1. Guide plate 2. Plate edge 3. Cutting line 1. Set the guide plate onto the guide rail near from the cutting start point. The plate edge represents the ...
8 english 2. Press the shaft lock fully so that the blade does not revolve, then loosen the hex bolt counterclockwise with the wrench. 2 1 1. Shaft lock 2. Hex bolt 3. Remove the hex bolt, outer flange and blade. 1 2 3 4 1. Hex bolt 2. Outer flange 3. Groove cutter blade 4. Inner flange to install t...
9 english groove cutting caution: be sure to move the tool forward in a straight line gently. Forcing or twisting the tool may result in overheating the motor and dangerous kickback, possibly causing severe injury. Caution: never approach any part of your body under the tool base when section cuttin...
10 english maintenance caution: always be sure that the tool is switched off and unplugged before attempting to perform inspection or maintenance. Caution: clean out the guard to ensure there is no accumulated sawdust and chips which may impede the operation of the guarding system. A dirty guarding ...
11.
Makita corporation www.Makita.Com 885435b4 en 20150608.
