Makita CA5000 Instruction Manual - Operation
8 ENGLISH
2. Press the shaft lock fully so that the blade does
not revolve, then loosen the hex bolt counterclockwise
with the wrench.
2
1
1. Shaft lock 2. Hex bolt
3. Remove the hex bolt, outer flange and blade.
1
2
3
4
1. Hex bolt 2. Outer flange 3. Groove cutter blade
4. Inner flange
To install the blade, follow the removal procedure in
reverse.
Be sure to tighten the hex bolt clockwise
securely. And close the blade case door after installing
the blade.
When changing blade, make sure to also clean the
guard of accumulated sawdust and chips as discussed
in the Maintenance section. Such efforts do not replace
the need to check guard operation before each use.
Connecting a vacuum cleaner
For groove cutting operation, connect a Makita vacuum
cleaner to your tool.
Connect a hose of the vacuum cleaner to the dust port.
1
2
1. Vacuum cleaner 2. Dust port
OPERATION
CAUTION: Always use a front grip and rear handle
and firmly hold the tool by both front grip and rear
handle during operations.
Guide rail
Optional accessory
Always use the guide rail for groove cutting operation.
Place the tool on the rear end of the guide rail.
Turn two adjusting screws on the tool base so that the
tool slides smoothly without a clatter.
1
1. Adjusting screws