Makita DA330D Technical Information - page 10
Be careful not to put these Lead wires
on or over Rib A and Boss A.
W
iring diagram
P 10/ 10
Fig. D-5
Fig. D-6
Wiring of Lead wires of LED Light circuit
(before setting Switch)
Wiring in Housing set (L)
(After setting Switch and DC Motor)
Connector
Lead wire holder
Lead wires have to be fixed
with Lead wire holders.
Lead wire holder
Lead wire holder
Boss A
Rib A
Terminal Rib B
Rib C
Rib D
LED Light circuit
Set LED Light circuit to
Housing set (L) while
facing Circuit plate to
DC motor side.
Projection
of Adhesive
Circuit plate
DC motor
side
Boss B
Red mark
DC Motor
Inflect (+) Terminal of DC motor so that
the terminal can be located between
Boss B and Rib C.
Inflect (-) Terminal of DC motor so that
the terminal can be located between
Rib C and Rib D.
Switch
Put Lead wire (red) between Rib B
and Switch.
Be careful not to put this wire (red)
on or over Rib B.
Put the slag of Lead wire (red) between
Rib C and Switch as drawn above.
Put the slag portion of Lead wires
to this place (about under Switch).