1 english (o rigina l in st ruct ions) instruction manual important: read before using. Cordless caulking gun dcg140 dcg180 013564.
2 english (original instructions) specifications model dcg140 dcg180 max feed force 5000 n feed speed 0 - 28 mm/s with short (300ml) holder 214 mm stroke with long (600ml) holder 350 mm with short (300ml) holder 404 mm overall length with long (600ml) holder 538 mm standard battery cartridge bl1415 ...
3 enh101-17 for european countries only ec declaration of conformity makita declares that the following machine(s): designation of machine: cordless caulking gun model no./ type: dcg140, dcg180 conforms to the following european directives: 2006/42/ec they are manufactured in accordance with the fol...
4 power tool use and care 17. Do not force the power tool. Use the correct power tool for your application. The correct power tool will do the job better and safer at the rate for which it was designed. 18. Do not use the power tool if the switch does not turn it on and off. Any power tool that cann...
5 5. Do not short the battery cartridge: (1) do not touch the terminals with any conductive material. (2) avoid storing battery cartridge in a container with other metal objects such as nails, coins, etc. (3) do not expose battery cartridge to water or rain. A battery short can cause a large current...
6 • overloaded: the tool is operated in a manner that causes it to draw an abnormally high current. In this situation, release the switch trigger on the tool and stop the application that caused the tool to become overloaded. Then pull the switch trigger again to restart. If the tool does not start,...
7 lighting up the lamp caution: • do not look in the light or see the source of light directly. 1 013570 pull the switch trigger to light up the lamp. The lamp keeps on lighting while the switch trigger is being pulled. The lamp goes out approximately 10 seconds after the switch trigger is released....
8 installing holder 013561 013562 hold the bottom of the holder and the holder joint, then turn the holder clockwise. Tighten it firmly until it stops. Make sure the holder is tightened firmly. Otherwise the tool may be damaged. To remove the holder, turn it counter clockwise. Note: • you can rotate...
9 installing film type pack notice: • make sure the piston b is attached to the rod. Do not use other type of piston for film type pack. • film type pack can be installed in the long holder (600ml) only. Remove the holder cap, the nozzle and the rubber ring from the holder. Pull the rod handle backw...
10 maintenance caution: • always be sure that the tool is switched off and the battery cartridge is removed before attempting to perform inspection or maintenance except for the following troubleshooting related to the light. • never use gasoline, benzine, thinner, alcohol or the like. Discoloration...
11.
12 www.Makita.Com makita jan-baptist vinkstraat 2, 3070, belgium makita corporation anjo, aichi, japan 885260a229.
