Makita DSC250 Instruction Manual - Maintenance
12 ENGLISH
Replace the Tipped Saw
1
Fig.12
► Fig.12: 1. Push (Lock Button)
1.
Fit the Tipped Saw over the Output Gear, making
sure that the slot in the flange is properly aligned with
the key.
2.
Replace the Tipped Saw Guide.
3.
Replace the Bolt and Washer.
4.
Push in the Lock Button completely to prevent the
Tipped Saw rotating and tighten the Bolt with the hex-
agonal wrench.
CAUTION:
Ensure that the Lock Button
is completely pushed in. If not, the hexagonal
wrench can rotate and may cause personal injury.
5.
Replace the Tipped Saw Cover.
6.
Tighten the Tipped Saw Cover Retaining Bolts (4
pieces) with a hexagonal wrench.
MAINTENANCE
CAUTION:
Always ensure that the tool is
switched off and the battery is removed before
attempting to perform inspection or maintenance.
NOTICE:
Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
1
Fig.13
► Fig.13: 1. Dust Cover
Remove the Dust Cover from the air vent and clean it
for proper air circulation.
CAUTION:
Clean the Dust Cover when it
becomes clogged. Continuing operation with a
clogged dust cover may damage the tool.