Mediastar Evolution 775 Quick Start Manual - page 4
Stream Setup
Defines the details of the video and audio streams
being produced.
SDP Files
This functionality retrieves files conforming to the
Session Description Protocol (SDP). These files are
used by some players/decoders to select an MPEG-4
stream.
Video Input
Select the video input connector(s) and video
format for the source signal to be encoded:
CVBS (Composite), S-Video, RGB, SCART (RGB with sync
on Composite), YPbPr (Component).
Select the video format: PAL or NTSC
Set interlacing: Progressive or Interlaced
Set the video aspect ratio: 4:3 or 16:9
IP Configuration
Network configuration of the Encoder is set up here.
These settings should be confirmed with your network
administrator before installing this unit on the
network.
Note that if the DHCP setting is used, following an
Encoder reset, the unit may be given an IP address
that is different from the one previously used.
Quick Start Guide
Medias
tar E
volution
4
PART NO. 200-2360
775QSG_v3