MEDIPREVENTIECENTRUM Pulse Oximeter Instructions To User - page 11
MEDIPREVENTIECENTRUM
Bestel in onze webshop. Telefoon:
074-2911110
(klantenservice)
Internet:
http://www.medipreventiecentrum.nl
E-mail:
info@medipreventiecentrum.nl
8 Troubleshooting
Trouble
Possible Reason
Solution
The SpO
2
and Pulse
Rate can not be
displayed normally.
The finger is not properly positioned.
Place the finger properly and try
again.
The patient’s SpO
2
is too low to be
detected.
Try again,go to a hospital for a
diagnosis if you are sure the
device works all right.
The SpO
2
and Pulse
Rate
are
not
displayed stably.
The finger is not placed inside deep
enough.
Place the finger properly and try
again.
The finger is shaking or the patient is
moving.
Let the patient keep still.
The device can not
be turned on.
The battery is drained away or almost
drained away.
Please charge battery.
The battery installation is incorrect.
Install the battery over again.
The malfunction of the device.
Please contact the local service
center.
The display is off
suddenly
The battery is almost drained away.
Please charge battery.
The device is set to shut down
automatically in 5 seconds when there is
no signal.
Normal.
The device can not
be used for full time
after charge
The battery is not full charged.
Please recharge the battery.
The battery is damaged.
Please contact the local service
center.
The battery can not
be full charged even
after
10
hours
charging time.
The battery is damaged.
Please contact the local service
center.
9 Key of Symbols
Signal
Description
Warning – See User Manual
%SpO
2
The pulse oxygen saturation (%)
PRbpm
Pulse rate (bpm)
Low-power indication
The alarm sound indication