Medvibe NitroFit Personal + A16814 Instruction Manual - page 13
13
Copyright © 2015 by Medvibe
- 13 -
Troubleshooting
TROUBLE
SOLUTION/ACTION
The LED screen will not illuminate
Flip the main power switch on the back of the base plate. If
the problem is not solved, check to ensure that vibration has
not disconnected the male and female connector’s in-be-
tween the stem and base plate. ( Note: This step may require
some product disassembly)
I can’t turn the NITRO FIT Personal + off Flip the main power switch on the back of the base plate of
an on to reset the machine.
The NITRO FIT Personal + is not stable
on the floor or surface I have.
Make sure that the machine is not place on uneven flooring
such as tile. For best results place machine on top of a level
rubber mat.
The stem seems to shake too much when I
use some of the higher speeds.
This is normal but could be a result of loose screws. Tighten
screws on the handlebars and base of stem.
The beaded base plate leaves marks on my
arms when I perform upper body exer-
cises.
The beaded plate acts as traction and massage. To avoid any
markings on your arms place a workout towel or small foam
pad on the platform when performing upper body exercises.
My body feels itchy when I get off of
my Nitro Fit Personal +.
This is normal and is your body’s response to increased
blood flow.
I often feel like I have to go to the
bathroom when using my Nitro Fit
Personal +
.
This is also normal and is your body’s reaction to the vibra-
tion. Use the restroom and resume your work out.
I sometimes get headaches when using my
Nitro Fit Personal +.
This is usually due to dehydration. Drink plenty of water bef-
ore using your machine.
I feel weak and tired from using my Nitro
Fit Personal +.
Vibration training can be strenuous. Make sure to eat a meal
at least 30 minute before you use your machine.
+