Meec 001-097 User Instructions - page 25
EN
EN
44
45
WARNING! Release the trigger and unplug the tool from its power outlet before adjusting the tool or
installing accessories
Adjusting the auxiliary handle
The auxiliary handle can be placed in a variety of positions To adjust the auxiliary handle, turn the
handle anti/clockwise to loosen the band Slide the handle to the desired position then turn the
handle clockwise to secure it in place
oPERATIoN
Note: This tool includes an internal safety clutch that helps prevent tool damage by disengaging the
drill function if the drill locks in place
Adjust the mode selector to the desired function before using the rotary hammer drill Press the
release button and rotate the mode selector until it clicks in place with the desired function at
the indicator
NoTE:
• Only move the mode selector once the rotary hammer drill has stopped Attempting to move the
mode selector while the rotary hammer drill is engaged will result in abrupt tool rotation and
can cause property damage
• When moving the mode selector, make sure it clicks into the desired position If not actively
engaged, the mode selector could slip out of position resulting in tool damage
ADJUSTING THE DIffERENT fUNcTIoNS of THE RoTARy HAmmER DRILL
A Chiselling
B Lock-on button
C Impact drilling
D Mode indicator
E Angle adjustment
Impact drilling
Set the mode selector in impact drilling mode (C)
chiselling
Set the mode selector in chiselling mode (A)
Adjusting the angle of the chisel
Rotate the mode selector to the angle adjustment mode (E) You can now rotate the chisel to the
desired angle for chiselling When you have finished adjusting the chisel, rotate the mode selector
to the hammer setting to begin chiselling
1
Choose a work area that is clean and well lit Keep children and pets away from the work area
to prevent distraction and injury
2
Route the power cord along a safe route to reach the work area without creating a tripping
hazard or exposing the power cord to possible damage The power cord must reach the work
area with enough extra length to allow free movement while working
3
Secure loose work pieces using a vice or clamps to prevent movement while working
4
There must not be any objects, such as water pipes or electricity lines, nearby that will present
a hazard while working
PREPARATIoN of WoRK PIEcE AND WoRK AREA
• Choose a work area that is clean and well lit Keep children and pets away from the work area
to prevent distraction and injury
• Route the power cord along a safe route to reach the work area without creating a tripping
hazard or exposing the power cord to possible damage The power cord must reach the work
area with enough extra length to allow free movement while working
• Secure loose work pieces using a vice or clamps (not included) to prevent movement
while working
• There must not be any objects, such as pipes, nearby that will present a hazard while working
mASoNRy DRILLING
changing drill bits
NoTE: Wear heavy-duty work gloves to provide protection when inserting and removing drill bits Drill
bits become very hot during use Do not remove drill bits until the bit has cooled Do not strike bits
that have become stuck with a hammer
1
Release the chuck
2
Check that the drill bit is secured in place You should not be able to pull it out of the chuck
3
Grease the drill bit shank before installing
4
Pull back on the chuck and insert the drill bit Make sure it slides all the way into the opening
NoTE: When drilling a hole larger than 1 1/4” in diameter, use a drill bit with four cutting edges
Impact drilling
1
Adjust the auxiliary handle as needed
2
Set the function by adjusting the mode selector to the desired setting
3
Plug in the power cord