Megamaster MODO FIRE PIT - Y3 Assembly & Operating Instructions - Storage
9
5.Do not allow the internal gas components to become wet, dry them immediately before
storing away to avoid any damage to these components.
6.Clean the controls and burner with a soft brush and compressed air. Make sure the patio
heaters airflow is not obstructed in any way.
7.
Open the top back door to clean debris on glass carefully using a soft cloth.
Signs of Gas Obstructions
1. If the flame burns with a yellow tip and there is a gas odour.
2.The patio heater dies not reach the desired temperature.
3.There is an uneven burn on the surface of the burner
4.The patio heater is making a popping noise
5.The flame flashes back into the burner tube and make a loud roaring noise.
Repairing and Service
Examine all fixtures and tighten where needed, check for gas leaks using a solution of soapy
water and spray on appropriate joints. Should you wish to service the patio heater take it to a
qualified person or company.
STORAGE
1. Always close the gas valve of the gas cylinder after use or in case of a disturbance.
2. Remove the pressure regulator and the hose.
3. Check the tightness of the gas valve and for damage. If you suspect a damage, have it changed by your
gas dealer.
4. Never store LP Gas cylinder in a sub-terrain, or at places without adequate air ventilation.