Megasat HD 510 User Manual - page 35
13
EN
Blind Scan
First scan the band to get the transponders which can be locked. After gathering all Transponders, Scan
the transponders one by one to get the programs.
5.3.2 Transponder
Press GOTO to switch the list to show transponders of the focused satellite. Also you can press GOTO to
switch back to satellites' list.
Add transponder:
Press RED to add a new transponder. It can't save an existing TP under the same satellite.
Edit transponder:
Press GREEN to edit the focused transponder. It can't save an existing TP under the same satellite.
Delete transponder: Press YELLOW to delete the focused transponder. Press OK to confirm.
Single Transponder Scan:
Press BLUE to pop the menu of scanning setting. After configuring the settings, Press OK to start
scanning.
Multi-Transponder Scan:
Press OK to select transponders with the mark"9",then press BLUE to pop the menu of scanning setting.
After Configuring the settings, press OK to start multi-transponder scanning.
5.4 Time
Setting
To access the Menu, press MENU then select [Time]. The Menu
provides options to adjust the time settings. Press / to select
an option and press / to adjust the settings. Press EXIT to exit
the menu.
(1)Time Auto: Update time with the stream time, or NOT.
(2)Time Zone: Select the Time Zone Offset.
(3)Date: Show and set the system date.
(4)Time: Show and set the system time.
5.3.3Unicable
Unicable enables the delivery of broadcast programming to multiple users over a single
coaxial cable. It should work with Unicable LNB or SaTCR equipment.
Set the Unicable ON, and select a channel which isn't occupied by other users.
Dish setup with Unicable
When unicable activated, the DiSEqC1.0, DiSEqC1.1, DiSEqC1.2,DiSEqC1.3 are disabled.
Set Pos A/B for satellites if the equipment can support.