Meguiar’s G110 Instruction manual - Variable Speed
TO START AND STOP POLISHER
1. CAUTION: Make certain the switch
is in the “OFF” position, and the power
source is the same as specified on the
tools nameplate.
2. Connect the tool to the power source.
3. Slide the switch button (A), Fig. 1,
forward to start the motor. Slide the
switch button rearward to stop motor.
VARIABLE SPEED
Speed is adjusted by turning thumbwheel
(a), Fig. 2. Thumbwheel position #1
provides the slowest operating speed
and position #6 the fastest. Speed may
be changed while motor is running or
while it is stopped (polisher works best
on settings between position 3-5).
HANDLE
A handle (A) Fig. 3 is furnished with
the polisher. Slide handle around tooth
and groove area of the body and insert
two screws (provided) to secure the
handle.
CHANGING THE BACKING PLATE
1.
DISCONNECT
POLISHER FROM POWER SOURCE.
2. Position spindle wrench (A) Fig. 4,
(furnished with polisher) to engage the
flats on the spindle (B) Fig. 4.
Notes:
A. It may be necessary to rotate
the backing plate (by hand) to
expose the spindle flats.
B. Photo shows polisher with
backing plate removed for clarity.
3. While holding the spindle with
the wrench, rotate the backing
plate counterclockwise (by hand) to
remove.
4. To install backing plate, reverse the
above procedure.
A
A
A
B
A
Fig. 1
Fig. 2
Fig. 3
Fig. 4
OPERATING INSTRUCTIONS
WARNING:
6