Meguiar’s G110 Instruction manual - Directions:
Never run the polisher while the pad is
off the surface of the vehicle, Always
start and stop machine with the pad
on the work surface (Fig. 5).
Use light to moderate pressure on
machine when applying product.
Polisher works best on speed settings
between 3-5.
Apply product sparingly directly to the
pad in an “X” pattern (Fig. 6).
Work on completely cool surface and
in shade.
When using a cleaner or polish, apply
to one panel at a time and remove the
product – do not allow to dry.
When applying a wax / paint protection,
apply to entire car, let product dry to
a haze, then remove.
Mark each pad to avoid mixing products
applied to previously used pads.
Hold machine so that the pad is facing up.
While applying light pressure using your
index and middle finger inside a clean
towel (Fig. 7), turn machine on to clean
product out of the pad. The pad should
be cleaned at the end of the job while
pad is still moist with product. For best
results clean pad prior to storing. Also,
clean pad again at the start of the next
usage while pad is still dry.
DIRECTIONS:
Wash and dry your car completely. Pull vehicle into covered
area. Evaluate the surface to determine which products are necessary.
Choose the correct product. Apply product to pad, place machine on
surface, turn machine on and begin applying product. (Do not turn machine
on until it is on the surface!) Work product evenly and thoroughly into surface.
Re-apply product sparingly to pad as needed. Remove product with a clean,
dry, high quality cotton terry cloth or microfiber towel by hand.
Fig. 5
Fig. 6
Fig. 7
G110/G220/G220EU
Using The Polisher
USAGE TIPS:
CLEANING THE PAD:
7