Meicheng CMLUX-88S Operation Manual - page 8
7. Operation Controls and Functions
The following sections describe the hardware components of the unit.
7.1 Front Panel
①
LCM monitor: This monitor displays your setting information with each
output and input selection.
②
IR sensor.
③
POWER: Press this button to turn on the system. When system is ON the LED
will illuminate in GREEN. Press it again to enter into STANDBY mode, the LED
will illuminate in RED.
④
EDID: Press this button to select the EDID function from the LCM. There
will be two selection available shown in LCM; 1. TV Mode and 2. Standard
Mode, press the number key to select the desire input first then press 1 or
2 to select the EDID mode. The LED will illuminate while setting the EDID.
After the selection is made, press enter key to confirm. Standard mode
means the device will use internal built-in EDID and TV mode means the
device will use TV/display’s EDID. When EDID switched to TV, leave as it is
if the displays are properly. Factory default setting is on TV mode.
Notes:
1. When EDID switch to TV the device will detect the first HDMI output
source’sEDID from A~D and record in t
he unit regardless of the HDMI output source from E~H. If the first
detected output source is DVI it will pass to next source,until the first
HDMI is detected. The detection priority is HDMI v1.3 > HDMI v1.2 > DVI.
Therefore, to ensure all output displayable outpt E~H must obtain lower
standard than output A~D.
2. When EDID is on STD, the device will use the built-in EDID
Video Supports
Audio Supports = PCM2
①
②
⑩
③ ④ ⑤ ⑥ ⑦ ⑧ ⑨
4