Meicheng CMLUX-88S Operation Manual - page 9

⑤

  LOCK: Press this button to lock all functions and press it again to release 

the lock function.  When LED illuminate in GREED, lock function is activate.  

If the LED is not illuminate, the key lock is released.

⑥

  ENTER: Press this button after each and every selection to confirm the 

setting.  If this button is not pressed after 20 second of the selection, the 

selection will be avoid.

⑦

  ALL: Press this button to set all the outputs to display with the same input.  

After press this All button press an input number and press enter to confirm 

the selection. 

⑧

  MEMORY: Press this button to set your desire setting total of 6 sets.  Press 

the desire setting number first.  When all the input/output are being set, 

press MEMORY to record into the system and there are 6 settings can 

record into the system.  Factory default setting is 1.12345678, 2.87654321, 

3.11223344, 4.55667788, 5.11221122, 6.33443344.

⑨

  RECALL: Press this button to recall the previous setting from memory total 

of 6 sets, and select from 1~6 for the desire setting.  Press enter button to 

confirm the selection.

⑩

  OUT A~H & IN 1~8: Press the output sources selection to correspond the 

input ports. Press first your output selection from A~H and wait for 2 sec. 

and press again the input selection from 1~8 then press the enter button 

to confirm your setting.  Each output selection only allows a single input 

setting each time.

5