Modor NF-1 User Manual - page 5
10.5. SYSEX BANK DUMPS
CHAPTER 10. ADDENDA
Therefore, a safety mode has been installed in OS004. When this Safety Mode is
activated, the sound parameters do not change when turning a frontpanel knob, until
you are passing it’s actual value. This setting can be found in the SYSTEM SETTINGS
menu. Activate the menu by pressing MENU 6x, and use the SELECT-encoder to select
this setting. Change it using the VALUE-control.
When Safety Mode is activated and you turn a knob on the frontpanel, a ’*’ is
displayed when the parameter change is blocked. This safety block is released when
you turn the knob passing the actual value, and the ’*’ dissapears. So, if you want
a parameter to change, you need to ’go get it’ at it’s actual setting and turn it up or
down to a new value. This way sudden changes of the sound are prevented. It’s also
sometimes called a ’Takeover Mode’,
10.5
Sysex bank dumps
Added in software version OS001
Sometimes you might want to dump a group of patches to share with other musi-
cians, to make a backup or to move a group of patches to another location in the mem-
ory. A full memory sysex dump is too big for that, while single patch sysex dumps may
be too complex to share a larger group of patches. Therefore the Sysex Bank Dump
option has been added. Before dumping, you select which bank of 32 patches [A-N]
you want to dump.
Bank Dump
Select the SYSEX DUMP menu with the MENU button, and use the
SELECT-encoder to select the Bank Dump option. Next, push MENU again to get into
the following screen:
Now use the SELECT encoder to select which bank to dump, and press SRC/YES
to start the sysex dump (or DEST/NO to cancel).
Bank Receive
A sysex bank dump is only received when your NF-1 is in the SYSEX
DUMP-menu, on the Bank Receive option. This is necessary to select at what location
[A-N] the incoming bank dump is to be saved. An incoming Sysex Bank Dump is
ignored when the NF-1 is not in this menu mode. If the reception of bank dumps
doesn’t seem to work, it’s probably because you need to get into this menu option.
3