Moduline Systems A Operation Manual - page 5
of
9
3
Reliable liquid dispensing
at an affordable price
3. Hold down the hand control dispense button or initiate a prime cycle by moving the prime
switch to the down position until all reagent has been removed from the system.
4.
After the system is empty, it should be flushed with an appropriate cleaning solution, if
desired, and finally with distilled water. This is done by placing the Teflon reagent pickup
straw into the liquid and again priming until the system is completely rinsed of the reagent.
It is
recommended that the system be left “wet” until the next use. If possible the
manifold should have its needles submerged in water to prevent drying out and
possible clogging.