1. DL manuals
  2. Moffat
  3. Hob
  4. MEH 630
  5. Instruction Booklet

Moffat MEH 630 Instruction Booklet

Summary of MEH 630

  • Page 1

    Electric hob meh 630 instruction booklet please read this instruction booklet before using the appliance keep this instruction book for future reference and ensure it is passed on to any new owner. 1 3 2 5 4 6 7 1. Hob top 2. Normal hotplate - 1570 w -180 mm dia. 3. Normal hotplate - 1040 w - 145 mm...

  • Page 2: Important Safety Information

    The following symbols will be found in the text to guide you throughout the instructions: safety instructions step by step instructions for an operation hints and tips environmental information you must read these warnings carefully before installing or using the oven. If you need assistance, contac...

  • Page 3: Operation

    Operation electric hotplates to switch on a hotplate, turn the relevant control knob anticlockwise to the required heat setting. The control knob is numbered 1 - 6 off 0 minimum 1 to keep food warm very gentle to melt butter and chocolate gentle 2 to prepare cream-sauces, stews and milk puddings or ...

  • Page 4: Something Not

    Symptom there is no spark when lighting the gas solution check that the unit is plugged in and the electrical supply is switched on check that the rccb has not tripped (if fitted) check the mains fuse has not blown check the correct control knob has been turned. Symptom the plate is not giving satis...

  • Page 5: Guarantee Conditions

    We, moffat, undertake that if, within 12 months of the date of the purchase, this moffat appliance or any part thereof is proved to be defective by any reason only of faulty workmanship or materials, we will, at our option, repair or replace the same free of any charge for labour, materials or carri...

  • Page 6: Location

    Important safety requirements this hob must be installed in accordance with the iee wiring regulations (current edition). Detailed recommendations are contained in the following british standards codes of practice: b.S. 6172/ b.S. 5440, par. 2 and b.S. 6891 current editions. Location minimum distanc...

  • Page 7: Building In

    Fo 0763 fo 0764 dimensions are given in mm. Building in building over a cupboard or drawer if the hob is to be installed above a cupboard or drawer it will be necessary to fit a heat resistant board below the base of the hob on the underside of the work surface. It is also recommended to carry out t...

  • Page 8: Wiring Diagram

    L n wiring diagram the hob should be connected to a double pole switch with a minimum gap of 3 mm. Between the switch contacts and of a type suitable for the required load in compliance with the current electric regulations. The switch should be sited within 2m of the hob and be easily accessible up...