N-Com BX5 User Instructions - page 20
EN
20
11. RIDER-PASSENGER INTERCOM
11.1.
Rider-Passenger intercom pairing up
Make sure the BX5 is turned off;
Put both systems in Setting mode (press the “on” key and keep it pressed for 4 seconds,
until the blue LED starts to flash quickly);
Press the “n” key briefly on one of the systems (Channel 1 pairing up);
A “wait for connection” tone is emitted until the pair up procedure is not completed.
11.2.
Rider-Passenger intercom function
After carrying out the proper pair up procedure, turn on the two helmets. To activate the intercom
connection, starting from an N-Com system that has already been turned on, briefly press key "n".
Manual intercom connection
With BX5 turned on, briefly press “n”.
Manual intercom disconnection
With BX5 turned on, briefly press “n”.
12. BIKE TO BIKE INTERCOM
The N-Com system is used for bike-to-bike communication up to a distance of about 500 m*.
The BX5 system entails the use of a default “STANDARD” commands configuration, or the use of a
“FRIENDS” configuration that can be turned on from the N-Com Wizard or dedicated App.
The difference between the two configurations lies in the number of motorcycles that can be hooked
up: the STANDARD configurations allows up to 3 different motorcycles to be hooked up to the BX5
system, while the FRIENDS configurations allows up to a total of 6.
Important: If you use the FRIENDS configuration, you need to visit the N-Com website and download
the dedicated commands diagram (section Download/Command Summary Diagram).
N.B.: The range and quality of the communication may vary significantly depending on the presence
of obstacles, weather conditions, magnetic fields.
N.B.: The range of the communication varies depending on the N-Com systems used.
*Measured in an open field, with no obstacles. The actual range may vary depending on the helmet
model used. For additional details, visit www.n-com.it
12.1.
Bike-to-Bike Intercom Affiliation (Standard configuration)
Make sure the BX5 is turned off;
Put both systems A and B in Setting Mode (press the “on” key and keep it pressed for 4
seconds, until the blue LED starts to flash quickly);
On system A, press the command related to the “setting position” where you wish to store
system B;
Pairing up CHANNEL 1
Briefly press “n”.
Pairing up CHANNEL 2
Press the “n” key twice.
Pairing up CHANNEL 3
Press the “n” key three times.
Pairing up CHANNEL 4
Briefly press “on”.
Pairing up CHANNEL 5
Press the “on” key twice.
Pairing up CHANNEL
Press the “on” key three times.