N-Com ESS User Instructions - page 4
EN
4
1.
WARNINGS AND SAFETY
Read this User Manual carefully, as well as the simple rules listed below. Failure to comply with these rules may
lead to dangerous situations.
Caution: The product cannot be used in official or non-official competitions, motordromes, circuits, racing
tracks and the like.
Caution: Installation of the N-Com ESS system results in a weight increase of approximately 50g, which is
added to the weight of the helmet and of the other accessories.
Warning: The electronic components of the N-Com system mounted inside the helmet are not waterproof.
Consequently, make sure the inside of the helmet, including the comfort padding, does not get wet in
order to avoid damage to the system. If it does, remove the N-Com system and the helmet comfort
padding and let it air dry. Disconnect the battery connector and let it dry as well.
1.1.
Road safety
Always obey all Traffic Regulations in force. While riding the motorcycle, your hands should always be engaged
in actually riding the vehicle. Any operation to the N-Com system must be carried out with the vehicle stopped.
Specifically:
In all cases, obey the Traffic Regulations and remember that riding the motorcycle has absolute priority
over any other maneuver.
The ESS system is equipped with an emergency brake light (ESS – Emergency Stop Signal). The ESS
system IS NOT intended to replace the stop or brake lights fitted on the motorcycle, consequently its
operation alone is not enough for proper brake signaling.
Make sure that the use of the emergency brake light (ESS – Emergency Stop Signal) is not in conflict
with the regulations in force in the country where you will be travelling.