NAD C715 Owner's Manual - page 15
LISTENING TO AM/FM
The C 715’s internal AM/FM tuner offers very high quality sound from radio
broadcasts. The reception and sound quality will always be dependent to a
degree however on the type of antenna(s) used as well as proximity to the
broadcast origin, geography and weather conditions.
SELECTINGAM/FM
Press [SoURCE] button repeatedly until AM/FM/DAb mode.
Toggle the [bAND] button to select AM or FM band.
ABOUT ANTENNAS
Connect the supplied lead-type FM antenna to the FM antenna input.
Extend the lead. Experiment freely with your antenna placement and
orientation until you get the clearest sound and lowest background noise.
Fix the antenna in the desired position by using thumb tacks, push pins or
any suitable means. In areas of poor FM reception, an exterior FM antenna
can improve performance dramatically. If radio listening is important to you,
consider consulting an antenna installation professional to optimize your
system.
The supplied AM ‘loop’ antenna will usually provide adequate reception.
however, an exterior AM antenna can be used to improve reception.
Consult an antenna professional for more information.
ASSEMBLING THE LOOP ANTENNA
1 Rotate the outer frame of the antenna.
2 Insert the bottom edge of the outer frame
into the groove on the stand.
3 Extend the antenna cord.
TUNING MODE
Toggle front panel’s [TUNE MoDE/SElECT] button (or SR 7’s [MEMoRy/
SElECT] key) and the upper display will show [Manual Tune], [Auto tune]
and [Preset tune].
MANUALTUNE
Press [
/
/
/
] on the front panel (or SR 7’s [TUNE
])
momentarily to step up or down between AM or FM frequencies. Release
the button when you find your desired station.
AUTOTUNE
Press [
/
/
/
] (or SR 7’s [TUNE
] key) - the C 715 will stop
at the next sufficiently strong signal it encounters. Pressing [
/
/
/
] during the search process will stop the search.
PRESETTUNE
Use the [
/
/
/
] on the front panel to step up or down
between presets. Press and hold [
/
/
/
] to scroll
continuously up or down. The SR 7’s [TUNE
] key work similarly. Empty
presets will be skipped during tuning.
SETTING RADIO PRESETS (AM / FM / DAB)
The C 715 can store up to 30 FM, 30 AM and 10 DAb stations for immediate
recall.
MANUALPRESET
1 Toggle the [bAND] button to select AM, FM or DAb.
2 To store a radio preset, first tune the desired frequency (see above), then
press SR 7’s [MEMoRy] key.
“Ch _ _” starts blinking indicating that it is waiting for you to enter your
desired preset number allocation. Use the Direct-Entry numeric keypad
buttons to enter the desired preset number. For example, to enter
Preset number “1,” press “0” and then “1”. Note that the as the first digit “0”
is keyed-in, “Ch0 _” is blinking indicating that it is waiting for the second
digit to be entered. Upon entering the second digit (i.e., number
“1”), “Ch01” stops blinking. This indicates that the first preset entry is
completed.
The same condition applies for DAb mode with “01” of the displayed
“PRESET MEMoRy 01” blinking also.
3 Repeat steps 2 and 3 to store up to 30FM, 30AM and 10 DAb stations.
NOTE
Anewstationcanbedirectlyenteredintoanexistingprogrammed
MemoryPreset.Thenewstationwilloverwriteallthedatapreviously
heldonthatPresetnumber.
OPERATION
USINGTHEC715–TUNERMODE
15
EN
G
LI
SH
FR
ANÇ
AIS
ESP
AÑOL
IT
ALIANO
DEUT
SCH
NEDERL
ANDS
SVENSK
A
РУ
ССКИЙ