NAD CI980 Owner's Manual - page 9
REFERENCE
TROUBLESHOOTING
CONDITION
POSSIBLE CAUSES
POSSIBLE SOLUTIONS
No power.
• The power cord is disconnected.
• Plug the power cord into the wall outlet
securely.
• CI 980 at standby mode.
• Press front panel STANDBY button to switch
ON the CI 980 (TRIGGER OFF/ON/AUTO
switch set to OFF position).
• Rear panel POWER switch not at ON setting.
• Set the rear panel POWER switch to ON
setting.
CI 980 always at standby mode; cannot
be switched ON using the front panel
STANDBY button.
• TRIGGER OFF/ON/AUTO switch set to “AUTO”
position.
• Slide the TRIGGER OFF/ON/AUTO switch to
“OFF” position.
• The CI 980 is not powered OFF using the front
panel STANDBY button.
• Power ON the CI 980 in the same manner it
was deactivated.
No sound.
• Power AC lead unplugged or power not
switched ON.
• Check if AC lead is plugged-in and POWER
switched ON.
• No input signal applied through the rear panel
INPUT terminals.
• Check that there is active input signal
applied through the rear panel INPUT
terminals.
No sound one channel.
• Speaker not properly connected or damaged.
• Check connections and speakers.
• Input lead disconnected or damaged.
• Check leads and connections.
Weak bass/diffused stereo image.
• Speakers wired out of phase.
• Check connections to all speakers in the
system.
9
ENGLISH
FR
ANÇ
AIS
ESP
AÑOL
IT
ALIANO
DEUT
SCH
NEDERL
ANDS
SVENSK
A
РУ
ССКИЙ