NAD M15 Owner's Manual - page 7
7
In case you simply cannot wait to experience the performance of your new NAD M15 A/V
Surround Sound Preamplifier, we provide the following “Quick Start” instructions to get
you underway. Follow the steps below for connecting your DVD player, TV/monitor, and
multi-channel amplifier to the M15. (see Figure 2 or Figure 3 depending on the type of
TV/monitor used). We strongly advise that all equipment be switched off and have the
power cables disconnected from the AC-power before proceeding.
FOR TV/MONITORS WITH COMPONENT CONNECTIONS (FIGURE 2)
• Connect the M15’s COMPONENT VIDEO OUT Y-C
B
/P
B
-C
R
/P
R
jack to your TV/monitor’s
corresponding input.
• Connect your DVD player’s Composite output to the M15’s DVD COMPOSITE VIDEO
IN.
FOR TV/MONITORS WITH HDMI CONNECTIONS (FIGURE 3)
• Connect the M15’s HDMI OUT jack to your TV/monitor’s corresponding HDMI input.
• Connect your DVD player’s HDMI output to the M15’s HDMI IN 1 jack.
AUDIO CONNECTIONS (FIGURE 2 OR FIGURE 3)
• Connect the DVD player’s coaxial digital output to the M15’s COAXIAL IN 1 input.
• Connect the M15’s AUDIO PRE-OUT outputs to your multi-channel amplifier.
• Connect your speakers to the multi-channel amplifier’s outputs, being sure to connect red
to red (“+”) and black to black (“-”), with care to avoid stray wires or strands crossing
between terminals. (Connect center, surround, and surround-back speakers as well, if
you like). If your system includes a powered subwoofer, connect the M15’s AUDIO PRE-
OUT SUBW1 jack to the subwoofer’s line input.
• Now connect all power cables from the equipment to the AC-power.
• Switch on the black rocker main POWER switch on the M15’s rear panel, see Figure 1
(this puts the M15 into Standby mode and illuminates an amber LED to indicate it is
ready to receive remote commands), and then press any of the front panel buttons to
power up the M15. Be sure the multi-channel amplifier and TV / monitor are powered
up, with the correct input selected.
• Start playback of the DVD player. Press the HTRM remote’s AMP DEVICE SELECTOR
button, and then its DVD1 button to select the DVD input. You should hear
multichannel or stereo sound, and see an image on the TV/monitor. (If one or the
other fails to appear, you may need to use their preamplifier’s on-screen menu
system to check assignment of audio, video, and digital inputs. Enjoy the movie or
music, but be sure to set aside time to read this manual thoroughly, and to set up,
calibrate, and configure your M15 carefully and completely.
Note: Coaxial, HDMI, and video interconnect cables are not supplied. Please contact
your NAD Dealer for supplying the latest high quality interconnect cables
.
QUICK START
Introduction
ENGLISH
FRANÇAIS
DEUTSCH
NEDERLANDS
ESP
AÑOL
IT
ALIANO
POR
TUGUÊS
SVENSKA
FIGURE 1
M15 02 23 2006.qxd 3/7/2006 9:05 AM Page 7