NAD M32 Owner's Manual - page 13
EQ
The M32 has the following Tone Control levels – Treble, Bass and Balance.
Bass and Treble controls only affect the low bass and high treble leaving
the critical midrange frequencies free of coloration. The Balance control
adjusts the relative levels of the left and right speakers.
h : Slide to adjust treble, bass or balance level.
: Slide to turn ON or OFF Tone Controls. At OFF setting, tone
controls (Treble and Bass) are disabled or defeated – Balance option
remains available.
SETUP
The Setup menu contains the menu options for Speaker Setup, Source
Setup, Digital Output and Control Setup.
SPEAKER SETUP
SPEAKER COMPENSATION
The digital impedance compensation filter provides fine tuning of the
top octave to match your speaker impedance. This results in perfectly flat
frequency response at 20 kHz. The effect of this filter may not be audible*
but it is measurable and it compensates for the small effect of the digital
reconstruction filter that eliminates the 844 kHz sampling frequency of the
amplifier.
* The exception may be some electrostatic speakers that have very low
impedance at high frequency. The lower the HF impedance, the greater
the deviation from flat response.
SUB OUTPUT
At “ON” Setting, all subwoofer settings are in effect. At “OFF” setting, all
subwoofer settings are disabled. With Sub Output set to “ON”, the following
subwoofer settings can be setup.
IMPORTANT
Set the “Sub Output” option under “Speaker Setup” settings to “ON” for
the OUTPUT terminals to function as Subwoofer out. On the other hand,
the OUTPUT terminals will function as PRE-OUT if the “Sub Output”
option is set to “OFF”.
OPERATION
USING THE M32
13
ENGLISH
FR
ANÇ
AIS
ESP
AÑOL
IT
ALIANO
DEUT
SCH
NEDERL
ANDS
SVENSK
A
РУ
ССКИЙ