NAD T 585 Owner's Manual - page 13
brightneSS/contraSt/Saturation/SharpneSS/gamma
Picture Setting adjustment is available for the following options.
brightness: Adjust overall brightness of the image.
contrast: Adjust bright areas (white level) in the image.
Saturation: Adjust the dullness or richness of image color. A color
with absolutely no saturation is going to be gray. A color that is 100%
saturated is in its most intense form.
Sharpness: Picture sharpness could be easily lost during the
recording/playback process. Adjust sharpness to improve the fine
details of the picture
gamma: Adjust intensity of the picture non-linearly. Select when
an image’s dark portions appears obscure or bright portions become
brighter than necessary.
NOTES
• ThelevelofadjustmentforBrightness,Contrast,Saturationand
Sharpness(alldefaultedto“0”)rangefrom-4to+4whileGammais
from0.761upto1.315.
• ReferalsototheitemonPICTURESETTINGADJUSTMENTattheVIDEO
SETTINGsectionoftheREFERENCEpage.
video output
Turn ON/OFF either HDMI audio/video OUT or VGA OUT. HDMI OUT and
VGA OUTPUT can only be turned ON one at a time – if HDMI is set to ON,
VGA is automatically set to OFF and vice versa.
Scart (europe model onlY)
SCART carries both composite video and RGB signals. Select the video
output signal that will be routed over SCART OUT.
cvbS: Select to output composite video signals.
rgb: Split the signal into the three fundamental colors Red, Green and
Blue (RGB) resulting to greater picture resolution and elimination of
artifacts associated with traditional composite video signals.
AUDIO SETUP MENU
digital audio output
Each DVD disc has a variety of audio output options. Set the player’s Digital
Audio Output according to the type of audio system you use.
dolbY digital/pcm: Select DOLBY DIGITAL/PCM if an active digital
output is supplied to a Dolby Digital decoder (or an amplifier or other
equipment with Dolby Digital decoder). In this mode, the T 585 will
automatically switch between Dolby Digital and PCM depending on
the program encoded on the disc, with Dolby Digital given priority. DTS
is not possible with this setting.
Stream/pcm: Select Stream/PCM if an active digital output is supplied
to an amplifier or other equipment with DTS decoder, Dolby Digital
decoder and MPEG decoder. If the disc is neither of stream or PCM
format, there will be no audio output at this option.
pcm: Select when connected to a two-channel digital stereo amplifier.
DVDs encoded in Dolby Digital or MPEG will be automatically
downmixed to two-channel PCM audio. DTS cannot be downmixed to
two-channel PCM.
off: Select to turn off digital audio output. With this option, you will
have purely analog audio output.
NOTES
• Ifanactivedigitalaudiooutputsignalissuppliedtoareceiverorother
equipmentwithoutacorrespondingdigitaldecodingcapability,avery
loudnoisemaybeproducedwhichcouldpermanentlydamagethe
speakers.
• TheDTSDVDdiscsoundisplayedbackonlywhentheDVDplayeris
connectedtoareceiverwithaDTSdecoder.
5.1 Speaker Setup
This option allows you to configure the 5.1 CHANNEL AUDIO OUT of the
T 585. Digital audio output will not be affected by the settings done in this
section. Use [
] keys to select a menu item and [
] keys to adjust
the settings of the selected item.
Speaker Selection
Select a speaker that you want to adjust - Front L, Center, Front R, Rear R,
Rear L or Subwoofer.
Size
Small: Select if you have connected to a system with speakers that lacks
significant deep bass response - about 150Hz below.
large: Select if you have connected to a system with full frequency
speakers capable of deep bass response.
none: Select when you do not have a certain speaker connected.
Front L/R speaker’s size can only be set to “Large” or “Small”. If Front L/R
speaker’s size is set to “Small”, Rear and Centre speaker’s size can only be set
to “Small” or “None”.
Subwoofer’s size can be set only to “Large” or “None”.
volume
Adjust the output level of the selected speaker from -10dB up to a
maximum of 0dB.
diStance
Setting the Distance lets the speakers know how far the sound has to travel
to reach your set listening point. This allows the sound from each speaker to
reach the listener at the same time.
Distance can be adjusted within 1ft (0.30m) up to 20ft (6m).
DISTANCE setting is not applicable for Subwoofer.
OPERATION
uSing the t 585 – Setup menu
1
EN
G
LI
SH
FR
ANÇ
AIS
ESP
AÑOL
IT
ALIANO
DEUT
SCH
NEDERL
ANDS
SVENSK
A
РУ
ССКИЙ