NAD T 777 Owner's Manual - page 11
17 AC MAINS INPUT
r The T 777 comes supplied with a separate detachable mains power
cord. Before connecting the plug to the mains powers source,
connect firmly first the other end to T 777’s AC Mains input socket.
r Always disconnect the mains power plug from the mains power
source first, before disconnecting the cable from the T 777’s AC
Mains input socket.
r Connect only to the prescribed AC outlet, i.e., 120V 60 Hz (for 120V
version models only) or 230V 50 Hz (for 230V version models only).
18 SWITCHED AC OUTLET
r This convenience outlet can supply switched power to another
component or accessory.
r The total draw of all devices connected to this outlet must not
exceed 120 watts.
r It is powered ON and OFF by the front panel STANDBY button or by
the HTR 8’s ON and OFF keys.
19 POWER
r Supply the AC mains power to the T 777.
r When the POWER switch is set to ON position, the T 777 goes to
standby mode as shown by the amber status condition of the
Standby LED. Press the front panel Standby button or HTR 8 remote
control’s [ON] button to switch ON the T 777 from standby mode.
r If you intend not to use the T 777 for long periods of time (such as
when on vacation), switch off the POWER switch.
r With POWER switched off, neither the front panel Standby button
nor HTR 8 remote control’s [ON] button can activate the T 777.
IDENTIFICATION OF CONTROLS
REAR PANEL
11
ENGLISH
FR
ANÇ
AIS
ESP
AÑOL
IT
ALIANO
DEUT
SCH
NEDERL
ANDS
SVENSK
A
Р
У
С
СКИЙ