NAD T 777 Owner's Manual - page 6
1 STANDBY
BUTTON
r Press this button to switch ON the T 777 from standby mode. The
Standby LED indicator will turn from amber to blue and illuminate
the VFD. Pressing the STANDBY button again turns the unit back to
standby mode.
r The T 777 can also be switched ON from standby mode by pressing
any of the front panel buttons.
NOTE
In order to turn ON the T 777 from standby mode or back to standby
mode, the rear panel POWER switch must be in the ON position.
2 STANDBY
LED
r This indicator will light up amber when the T 777 is at standby
mode.
r When T 777 is powered up from standby mode, this indicator will
illuminate blue.
r If a Zone (Zone 2, Zone 3 or Zone 4) is ON and STANDBY button
is pressed to switch the T 777 to standby mode, the VFD will be
extinguished but the STANDBY LED remains illuminated blue.
This indicates a Zone (Zone 2, Zone 3 or Zone 4) is still active. The
corresponding active Zone icon(s) will also remain displayed in the
VFD.
r In order to completely shut down the T 777 with Zone 2, Zone 3
and/or Zone 4 still ON, press and hold STANDBY button until the
STANDBY LED turns amber.
r When infrared command from the HTR 8 is received, this indicator
will also flash momentarily.
3 NAVIGATION and ENTER BUTTONS
The navigation ([d/f/a/s]) and [ENTER] buttons have various
applications specific to given modes. The middle round button is
designated as [ENTER] button; this is normally pressed to complete a
selection, procedure, sequence or other applicable functions.
AM/FM mode
Toggle [ENTER] button to switch between “Tune” and “Preset” mode.
Select “Tune” mode.
r Pressing momentarily the [a/s] button will manually scan the AM
or FM band.
r Press and hold [a/s] for more than 2 seconds to search up or down;
the T 777’s tuner will stop at the next sufficiently strong signal it
encounters.
·
Note that this function “wraps” - that is, it will continue to search
from one end of the AM or FM band to the other until it stops at a
strong signal.
Toggle [ENTER] button to switch between “Tune” and “Preset” mode.
Select “Preset” mode.
r 6TF skipped over. Note that Presets must have been previously stored. Refer also to the item about STORING PRESETS (AM/FM/XM/DAB) at the LISTENING TO AM/FM RADIO section of the OPERATION page. XM mode (120V version model only) r Use the front panel [d/f] and [ENTER] buttons in combination with the [MENU] button to select through applicable XM menu options. DAB mode (230V version model only) r Use front panel [a/s] and [ENTER] buttons in combination with [MENU] button to select through applicable DAB menu options. 4 MEMORY r Press this button to store tuned AM, FM and digital radio stations to the T 777’s 40 preset-memory locations. One can store a mix of any AM, FM and digital radio stations to the 40 available presets. 5 INFO r Show information as supplied by the applicable source. r Toggle [INFO] button to display supplied information. IDENTIFICATION OF CONTROLS FRONT PANEL NAD T777 © NAD T 777 a SOURCE s VOLUME s a d f DELETE AM/FM/DB A SPEAKERS B TUNER MODE LISTEN MODE TONE TONE DEFEAT FRONT INPUT/MP AV Surround Sound Receiver T 777 MEMORY INFO 4 5 6 9 7 8 18 A B C E D 13 14 15 16 17 12 1 2 3 19 11 10 6 ENGLISH FR ANÇ AIS ESP AÑOL IT ALIANO DEUT SCH NEDERL ANDS SVENSK A Р У С СКИЙ