Nadatel CM-1040S User Manual - page 93
93 |
P a g e
o FRAME RATE
– # ~ # (Allows the user to change the recording FRAME RATE of the
selected CHANNEL)
o QUALITY
– LEVEL 1 ~ LEVEL 5 (Allows the user to change the recording QUALITY
of the selected CHANNEL)
o RECORDING
– CONTINUOUS, MOTION, SENSOR, SCHEDULE, DISABLE (Allows
the user to change the RECORDING type of the selected CHANNEL)
o SENSOR RECORDING
– Allows the user to set up to 4 sensors for selected
CHANNEL.
o PRE RECORD
– OFF, 15 SECONDS, 30 SECONDS, 1 MINUTE, 3 MINUTES, 20
MINUTES (Allows the user to set PRE RECORDING for selected CHANNEL)
o POST EVENT RECORD
– 10 SECONDS ~ 30 SECONDS, 60 SECONDS (Allows
the user to set POST EVEN RECORDING for selected CHANNEL)
o AUDIO
– ON/OFF (Allows the user to turn ON/OFF AUDIO recording for selected
channel)
10-3. DEVICE
ALARM-OUT
– 1 ~ 4 (Allows the user to select a specific alarm output terminal)
o SENSOR IN
– Allows the user to set ALARM-OUT when SENSOR-IN is triggered.
o MOTION ON
– Allows the user to set ALARM-OUT when MOTION is triggered.
o VIDEO LOSS ON
– Allows the user to set ALARM-OUT when VIDEO LOSS is
detected.