Nady Systems DW-11 Owner's Manual - Digital Ht

7

DIGITAL HT

TM

11. Windscreen   

         12. Battery Good/Low LED Indicator

13. Power On/Off  

         14. Battery Cover

15. Battery Compartment / 2 AA Batteries LT

    DIGITAL HT

TM

 HANDHELD MICROPHONE TRANSMITTER

HANDHELD OPERATION

1.  Unscrew  the  BATTERY  COMPARTMENT  COVER  (14)  and  insert  2  fresh  AA 

ALKALINE  BATTERIES  into  the  BATTERY  COMPARTMENT(15),  observing  the 

correct polarity as marked. Screw the cover back on to the microphone. Fresh alkaline 

batteries can last up to 11 hours in use, but in order to ensure optimum performance, 

it is recommended that you replace the batteries after every 8-10 hours of use.

2. Turn on the DIGITAL HT™  by sliding the POWER SWITCH (13) to turn on the 

TX first. The RF LED (3) on the DW-11/DW-22 receivers should now be lit, indicating 

a  received  signal  from  the  transmitter.  The  BATTERY  INDICATOR  LED  (12)  will 

give a single quick flash, indicating usable battery strength. In the case of a dead or 

low battery, it will either not go on at all or will stay on continuously, indicating that 

the batteries should be replaced with fresh ones. To preserve battery life, turn the 

transmitter off when not in use.

3. The microphone is now ready to use. Adjust the volume of the receiver per the 

Audio Output Microphone Connection section above.

[Note: Observe care in selecting P.A. volume, transmitter location and speaker place-

ment so that acoustic feedback (howling or screeching) is avoided.]